Rogue Ohio Deadlift Bar — Black Zinc
A 27mm deadlift bar at 190,000 PSI, 90.5 inches long with 56 inches between the sleeves — a longer span than a power bar, which is what produces the whip. No centre knurl.
That is not a photograph of this bar. Product photography on this page is illustrative. We are licensing real images of each bar and will swap them in per product as they arrive — until then the pictures show a generic unbranded bar of that type, not the product named beside them.
Published specification
Every figure below is Rogue Fitness’s or Rogue’s own published specification for this bar, quoted rather than measured. Where a figure is not published it is not listed — there are no estimates in this table.
Who this bar is for
For pulling only. The flex that helps you break a heavy bar off the floor makes it unsafe to squat or bench with, and the long span will not fit every rack.
What this page is not
It is not a review. Nobody at OlympicBars.co.uk has trained on this bar, so there is no score, no star rating and no verdict here, and there never will be unless that changes and we say so plainly. What this page gives you is Rogue’s own numbers, laid out the same way as every other bar on the site so you can compare them, and a link to the shop so you can check the current price yourself.
Other deadlift bars
A 27mm shaft and a longer span between the sleeves, so the bar bends before the plates leave the floor. Aggressive knurl, no centre knurl. Not for squatting or benching.
Every figure is the manufacturer’s or retailer’s own published specification. An em dash (—) means they do not publish that figure — it is never a number we have guessed. “Tensile” is tensile strength in thousands of PSI. “Rotation” is bushings, needle bearings, or both in the same sleeve. No prices are listed here, deliberately: check the current price with the shop.
All deadlift bars →Compare it against everything else
All 52 bars on one page, grouped by type, on the same set of published figures.
The full tableNot sure what the numbers mean?
Tensile strength, whip, knurl depth, bushings against bearings — what each one changes when you are actually under the bar.
Specs explained