Mirafit Talos 20kg Powerlifting Bar
A 29mm bar for the big three, with IPF knurl marks including a centre knurl, deep aggressive knurling and low whip. Load tested to 454kg — lower than Mirafit’s own Power Bar, which is tested to 680kg.
That is not a photograph of this bar. Product photography on this page is illustrative. We are licensing real images of each bar and will swap them in per product as they arrive — until then the pictures show a generic unbranded bar of that type, not the product named beside them.
Published specification
Every figure below is Mirafit’s own published specification for this bar, quoted rather than measured. Where a figure is not published it is not listed — there are no estimates in this table.
Who this bar is for
A straightforward powerlifting bar for a home gym. The 454kg test figure is the one to check against your own numbers before choosing it over the Mirafit Power Bar.
What this page is not
It is not a review. Nobody at OlympicBars.co.uk has trained on this bar, so there is no score, no star rating and no verdict here, and there never will be unless that changes and we say so plainly. What this page gives you is Mirafit’s own numbers, laid out the same way as every other bar on the site so you can compare them, and a link to the shop so you can check the current price yourself.
Other power bars
A 29mm shaft, almost no whip and a centre knurl that grips your back. Built for the squat, the bench press and the deadlift, and the standard diameter across powerlifting federations.
Every figure is the manufacturer’s or retailer’s own published specification. An em dash (—) means they do not publish that figure — it is never a number we have guessed. “Tensile” is tensile strength in thousands of PSI. “Rotation” is bushings, needle bearings, or both in the same sleeve. No prices are listed here, deliberately: check the current price with the shop.
All power bars →Compare it against everything else
All 52 bars on one page, grouped by type, on the same set of published figures.
The full tableNot sure what the numbers mean?
Tensile strength, whip, knurl depth, bushings against bearings — what each one changes when you are actually under the bar.
Specs explained